|
Technical Support -
Mechanical - Fuel Injector Manifolds
Return to Technical Support
How
to set the metering valve
Set
injector to wide open throttle. As pictured in the Metering
Valve Schematic,
the distance “X” between the center of the rod-end bearings
is equal to the disctance “Y” between the center of the throttle
shaft and the center of the metering valve rotor (#54 shown). Note that
the inlet fitting on the block is off-set to one side. Adjust the rotor
so that the number is located on the wide side of the off-set. Tighten
arm on the rotor and the throttle shaft.
Downloads
Metering Valve Schematic
|
